Project 2.9.6 Preventing Cutting Head Methane Emissions On Continuous Miners
Simulation work on face ventilation in mechanised coal sections, with methane sources modelled from the cut face, gathering arms, conveyors and shuttle cars. For ventilation engineers and equipment manufacturers.
By D Marais & AP Cook | April 2020
Computational fluid dynamics, checked against underground measurements, mapped ventilation flow and methane concentration around continuous miner headings for straights and splits, single and double scrubbers, side and straight scrubber discharges, jet fans, brattices and force columns. It showed the earlier physical test work cannot predict contaminant flow for larger machines or altered scrubber layouts.
R1500,00
Description
Browse below to see more detailed images from the CFD simulations which have been recorded
Related Products
Collation of Historic Thermal Imagery
2008
Pilot exercise pulling scattered thermal survey datasets held by companies and research bodies into one mapping system, with a view to tracking coal fires and mine water discharge.
What this report foundExisting thermal imagery of the Witbank coalfield was traced to its holders and assessed for format, quality, resolution and coverage, then brought into one...
R1500,00
Existing thermal imagery of the Witbank coalfield was traced to its holders and assessed for format, quality, resolution and coverage, then brought into one geographic information system with supporting metadata. Satellite thermal bands give a regional picture only; detailed mapping of coal fires or acid drainage discharge needs high resolution aerial surveys.
The Optimum Methodology for Conducting High Resolution, Shallow Reflection Seismic Surveys on South African Collieries
2001
Field procedure standards for high resolution seismic work over seams 30 to 100 m deep, trialled at two Mpumalanga collieries, with a cost comparison against exploration drilling.
What this report foundShallow reflection seismic surveys failed on South African collieries mainly because too little preliminary data, from vertical seismic profiles and noise...
R1500,00
Shallow reflection seismic surveys failed on South African collieries mainly because too little preliminary data, from vertical seismic profiles and noise spreads, was gathered before the surveys were designed. Following the field procedures set out here produces usable data for mine planning. For target depths under about 150 m, exploration drilling stays cheaper, because shot holes must be drilled below the weathered layer.
Evaluate the Remaining Resources of Low Phosphorus Coal in Mpumalanga Province
2004
Assessment of remaining metallurgical grade coal in the Witbank, Highveld and Ermelo coalfields from national borehole records, for resource planners and buyers of reductant coal.
What this report foundTonnage estimates for the remaining low phosphorus resource could not be produced, because the phosphorus analyses supplied by mining companies did not state...
R1500,00
Tonnage estimates for the remaining low phosphorus resource could not be produced, because the phosphorus analyses supplied by mining companies did not state what had been measured. Distribution trends were still mapped. Coal at or below 0.010 per cent phosphorus is widespread in the Witbank Coalfield, restricted to the far northwestern Highveld, and follows a northwest to southeast band in eastern Ermelo.
R1500,00