Create Sedimentological and Structural Models to Assist in Identifying Geological Features That Impact on Mining
Regional geology mapped in three dimensions from borehole data supplied by three mining groups, built for mine geologists and planners assessing seam disruption before layout design.
by Mark Grodner | December 2001
A three dimensional model of the northern Witbank and Highveld coalfield was built from more than 1100 borehole logs, with strata sorted into 13 major groupings and surface topography taken from satellite elevation data. It runs on open source visualisation software rather than a commercial package. Delays limited coverage to about a quarter of the coalfield.
R1500,00
Description
Related Products
Can old bord-and-pillar workings be mapped from surface?
2016
Desktop review updating two earlier assessments, weighing borehole scanning, robots and unmanned aerial platforms as routes to locating old workings ahead of opencast drilling and blasting.
What this report foundNo surface geophysical method can map individual bords and pillars at the depths typical of the Witbank coalfield, a limit the review attributed to physics...
R1500,00
No surface geophysical method can map individual bords and pillars at the depths typical of the Witbank coalfield, a limit the review attributed to physics rather than to technology, since the targets are small relative to their depth and conductive layers often lie above the seam. Borehole laser scanning remains the workable option, with sonar suited to flooded workings.
Fine Coal Dense-medium Cyclone Tests Conducted at Leeuwpan Coal Mine
2007
Pilot dense medium cyclone testing on fine coal inside a working spiral plant at a Mpumalanga opencast mine, ending in a full scale plant design.
What this report foundDense medium cyclones on the fine coal fraction lifted product yield well above the spiral circuit they were compared against and gave closer control of...
R1500,00
200720 pages
Dense medium cyclones on the fine coal fraction lifted product yield well above the spiral circuit they were compared against and gave closer control of product quality. Cut point density control proved the hardest part of running the plant, medium properties being critical. Magnetic separator capacity had to match the duty, and a basement was needed to contain and recover medium spillage.