Fine Coal Dense-medium Cyclone Tests Conducted at Leeuwpan Coal Mine
200720 pages
Pilot dense medium cyclone testing on fine coal inside a working spiral plant at a Mpumalanga opencast mine, ending in a full scale plant design.
by GJ de Korte | January 2007
Dense medium cyclones on the fine coal fraction lifted product yield well above the spiral circuit they were compared against and gave closer control of product quality. Cut point density control proved the hardest part of running the plant, medium properties being critical. Magnetic separator capacity had to match the duty, and a basement was needed to contain and recover medium spillage.
Contents
- 1. Introduction3
- 2. Coal quality4
- 3. Spiral Circuit5
- 4. Sampling5
- 5. Spiral and dense-medium cyclone compared6
- 6. Demagnetizing coil10
- 7. Grootegeluk test11
- 8. JK Cyclone Test13
- 9. Extended runs17
- Magnetic separator efficiency18
How it opens
Upon completion of the test work at Navigation, the Coaltech 2020 fine coal dense-medium plant was re-located to Leeuwpan Mine for the next phase of test work. The move of the plant was initially planned for the last quarter of 2005 but was delayed as a result of the commissioning of the new jig plant at Leeuwpan. The plant was transported to Leeuwpan during January 2006.
How it concludes
R1500,00
Description
Related Products
R1500,00
Models for Predicting Methane Gas Release from Coal Seams
2005
Emission factors and calculation models for national greenhouse gas reporting, built from mine seam gas measurements and ventilation sampling, for environmental staff and inventory compilers.
What this report foundEmission factors derived from measured South African seam gas data give simple models for methane released by underground mining, surface mining and coal after...
R1500,00
Emission factors derived from measured South African seam gas data give simple models for methane released by underground mining, surface mining and coal after mining. Applied across the industry they put total methane emissions at 52 000 to 93 000 tons a year. The models follow the IPCC Tier 2 approach using country specific factors.
Dry Processing of Coal – Progress Report: Tests Conducted on the IMS / Slater Coal Marketing Allair Dry Jig
2016
Test work on a dry jig installed at a Balmoral site, covering coal sized below 50 mm and duff below 12 mm, for producers considering waterless beneficiation.
What this report foundA 30 tonne per hour pilot Allair dry jig upgraded run of mine coal to thermal coal specification, but could not effectively beneficiate finer duff.
R1500,00
201613 pages
A 30 tonne per hour pilot Allair dry jig upgraded run of mine coal to thermal coal specification, but could not effectively beneficiate finer duff. Cut point densities and EPM values matched other dry processing equipment, though the jig appeared to give better control of the parameters governing separation. Four tests ran on run of mine coal and two on duff.